A braking unit is applied to models above 200kW in order to ensure enough safety and mobility when taking a run on normal roads. This type of trailer mounted genset is highly integrated for ready use at the destination. The gen set is mounted in a weatherproof canopy which features wind-duct, louvers and draining units. It is completely suitable for all-weather field work.
The side door is fit to each side of the weatherproof canopy for operation and service, and the doors can be locked by a special lock for safety of the gen set. There is a viewing window on the side of the canopy for convenient operation.
Inside the canopy, it contains fuel tanks and batteries. The biggest fuel tank can meet the requirements of 24 hours full-load running of the trainer mounted genset. According to the customers' requirements, the related equipment such as cable reel and cable adaptor can be installed additionally. Besides, soundproof type of the trailer mounted gen set is available as requested.
| Silent generator set canopy: |
| * With special treated steel sheet |
| * StaiVess steel locks  |
| * Control panel viewing window for monitoring the status of the generator set |
| * Good ventilation system and anti-heat radiation struction |
| * Effective anti-vibration devices to ensure the geneartor set run steadily  |
| * Super silent materials inside to ensure the noise lower than 68 dB 7 meters away |
| * Emergency stop button mounted outside |
| * Side lockable door easy for maintenance and installation  |
| * Lube oil and cooling water drains piped to exterior of the canopy |
| * Fuel tank built-in with level gauge |
| 1. Rated voltage: 400V/230V, 380V/220V, 240V/120V, 220V/110V |
| 2. Line way: 3 phases & 4 lines |
| 3. Frequency: 50Hz/60Hz |
| 4. Power factor: 0.8 (lagging) |
| 5. Frequency down (%): ≤ 0.5  |
| 6. Steady voltage windage (%): ≤ ± 1 |
| 7. Instantanous frequency windage (%): (rated power ) +10~ -7 Â |
| 8. Frequency recovering time (s): ≤ 3 |
| 9. Instantanous voltage windage (%): +20~ -15 Â |
| 10. Voltage recovering time (S): ≤ 4  |
| 11. Wave form distortion (%): ≤ 5 |
LED Heat Sink FEATURES:
The aluminum material is melted in high temperature and become liquid status, then we pour it into the mould,. After cooling down, the product could be finished easily. We will take good care during the cooling process to avoid the bubble occurs. There's wide range of shape for Heat Sink in die-casting process.
In addition, if the quantity is huge enough, the cost would me much cheaper.
Many complicated metal components are produced by this process.
â— High structural integrity
â— Smooth die casting parts surface
â— Reduce or eliminate secondary machining operation
â— Rapid production rate
LED Heat Sink
LED Heat Sink,Heat Sink,Die Casting Heat Sink,Aluminum Die Casting Heat Sink
Zheke Mould Technology Co. Ltd. , http://www.zkdiecasting.com