How is the failure rate of the electronic universal testing machine reduced?
In the actual use of the electronic universal testing machine, if the device does not work, the user can analyze the following reasons and find out the correct fault according to the cause, where:
1. Motor: When ensuring that the normal tensile tester is energized, the motor has been damaged and needs to be repaired or replaced.
2. Driver: The driver of the tensile testing machine is the key component to adjust the speed and holding force of the testing machine. When the normal motor has sound, and the machine does not work, most of the reasons are the driver setting or wiring problem, and need to communicate with the manufacturer. And guidance, generally do not need to return the drive to the factory or replace.
3. Temperature: The hydraulic universal testing machine works by the pressure of the hydraulic oil. If the oil temperature in the winter is too low, it needs to be warmed up for a few minutes just after starting, or there will be a short-time non-working state.
In order to reduce the failure rate during the use of the electronic universal testing machine, users should pay attention to the maintenance and maintenance of the electronic universal testing machine during its use, among which:
1. Regularly apply anti-rust oil to the relevant fixtures of the electronic universal testing machine to prevent long-term oxidation and rust of the equipment.
2. Check the tightness of the equipment itself and the related accessories screws to prevent it from falling off.
3. Due to the high frequency of the experiment, periodically check the condition of the electrical connection line in the controller.
4. The electronic universal testing machine needs to replace the filter element in time to prevent the valve body from being blocked.
5, observe the situation of hydraulic oil, regular replenishment, need to preheat in advance before starting the winter to more accurate measurement.
The Parts of Bottom Hemming Machine which is easily worn out and need frequent repairement are in common use in the Chainstitch and Lockstitch Bottom Hemming Machine.
General Purpose Parts For Bottom Hemming Machine
General Purpose Part,Bottom Hemming Machine,Common Parts,Damaged Part,Replacement Parts
DONGGUAN CHUANGHUI SEWING MACHINE CO.,LTD , http://www.ch-sewing.com